F 550 2WD Super Duty V10-6.8L VIN Z Bi-Fuel (2001)
Steering Column Lock: Service and Repair
Ignition Switch Lock Cylinder
Functional Lock Cylinder
Ignition Switch Lock Cylinder - Functional
Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the ignition switch lock cylinder.
1. Insert the ignition key and turn to the RUN position.
2. Using a 1/8-inch drift, press the ignition switch lock cylinder release pin through the access hole while pulling out the ignition switch lock
cylinder.
3. To install, reverse the removal procedure.
-
Verify ignition switch kick cylinder operation.
Non-Functional Lock Cylinder
Ignition Switch Lock Cylinder - Non-Functional
Removal and Installation
1. Disconnect the battery ground cable(s) to allow the depletion of the restraint system backup power supply.
2. WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions and notes in the deactivation
procedure.
Deactivate the Supplemental Restraints System (SRS).
3. WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes and instructions in the steering
wheel removal and installation procedure.