F 550 2WD Super Duty V10-6.8L VIN Z Bi-Fuel (2001)
23. Rotate the adjusting screw clockwise one half turn so the side cover will rotate freely on the sector shaft.
24. Install the sector shaft adjusting screw jam nut onto the sector shaft adjusting screw a few threads. Final adjustment will be made later.
25. WARNING: Do not weld or otherwise plug this hole in any permanent manner. This is a safety vent which functions only if the side
cover seal fails. If the seal fails and the plug cannot vent, the steering gear can lockup or otherwise function incorrectly.
Press the new vent plug into the hole provided in the side cover until the plug is bottomed.
26. Apply clean grease to the new side cover gasket to hold it in place and put the gasket on the side cover.
