F 550 2WD Super Duty V10-6.8L VIN Z Bi-Fuel (2001)
Use the pry bar and the wood block to remove the differential case from the rear axle housing.
9. Remove the ring gear bolts.
10. CAUTION: Care should betaken not to damage the ring bolt hole threads.
NOTE: The anti-lock speed sensor ring cannot be reused once removed.
Insert a punch in the bolt holes. Drive off the ring gear and, if necessary, the anti-lock speed sensor ring.
11. Install the differential case without the ring gear.
1
Position the differential case assembly, including bearing clips and shims, in the housing.
2
Install the differential bearing caps.
3
Install the differential bearing cap bolts.
12. NOTE: Rotate the differential case to make sure the differential bearings are properly seated.
