F 550 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
Removal and Installation
All vehicles
1. Disconnect the fluid level sensor connector.
2. If equipped, disconnect the brake pressure switch and the trailer brake control transducer electrical connectors.
3. Disconnect the brake tube-to-master cylinder fittings.
^
To install, tighten to 18 Nm (13 ft. lbs.).
Vehicles with vacuum booster
4. Remove the brake master cylinder nuts and the brake master cylinder.
^
To install, tighten to 27 Nm (20 ft. lbs.).
Vehicles with Hydro-Boost
5. Remove the power steering tube bracket nuts and position the bracket aside.
^
To install, tighten to 27 Nm (20 ft. lbs.).
6. Remove the brake master cylinder.
All vehicles
7. To install, reverse the removal procedure.
^
Bleed the brake system.