F 550 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
23. CAUTION: Do not use the special tool to raise the engine. Damage to the special tool or vehicle may occur.
NOTE: The ball studs may have to be removed.
NOTE: This procedure requires a second bolt hook assembly. The tools are available through Rotunda Tools with these numbers: bolt hook
303-F070-6, handle 303-F070-8, bracket 303-FO70-7 and washer 303-F070-12004.
Install the special tool.
24. NOTE: The engine must be raised evenly.
Using a lifting crane, raise the engine until the turbocharger is almost touching the cowl. Secure the engine with the special tool.
25. Remove the nut and position the battery cable and bracket aside.
^
To install, tighten to 30 Nm (22 ft. lbs.).
26. Remove the stud bolt and position the battery cable aside.
^
To install, tighten to 47 Nm (35 ft. lbs.).
27. Remove the 4 engine mount-to-engine mount bracket bolts.
^
To install, tighten to 62 Nm (46 ft. lbs.).
28. Remove the 4 engine mount bracket-to-cylinder block bolts, the engine mount bracket and the engine mount.
^
To install, tighten to 62 Nm (46 ft. lbs.).
