F 550 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
Intake Air Temperature Sensor: Service and Repair
INTAKE AIR TEMPERATURE 2 (IAT2) SENSOR
Removal and Installation
1. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
Turn the ignition switch to the OFF position.
2. Disconnect the intake air temperature 2 (IAT2) electrical connector and wiring harness retainer.
3. Remove the IAT2 sensor.
-
To install, tighten to 17 Nm (13 lb-ft).
4. To install, reverse the removal procedure.
