F 550 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
Transmission Cooler: Initial Inspection and Diagnostic Overview
Inspection and Verification - Manual Transmission
CAUTION: When internal wear/damage occurs in the transmission, component material can travel into the fluid cooler tubes and the in-tank
transmission fluid cooler. Remove these contaminants from the cooling system before placing the transmission back into use. For additional
information, refer to Transmission Fluid Cooler Flow Test - Manual Transmission and Transmission Fluid Cooler - Backflushing and Cleaning -
Manual Transmission. See: Service and Repair/Transmission Fluid Cooler Flow Test - Manual Transmission See: Service and Repair/Transmission
Fluid Cooler Backflushing and Cleaning - Manual Transmission
1. Visually inspect for obvious signs of mechanical damage, incorrect component installation, and system leaks. Repair as necessary.
^
Install a new or remanufactured radiator when fluid is found leaking from the in-tank transmission fluid cooler. For additional information,
refer to Cooling System.
2. If the fault is not visually evident, GO to Symptom Chart - Manual Transmission. See: Symptom Related Diagnostic Procedures
