F 550 2WD Super Duty V8-6.4L DSL Turbo (2008)
10. CAUTION: Fuel injection equipment is manufactured to very precise tolerances and fine clearances. To prevent fuel system damage, it is
essential that absolute cleanliness is observed when working with these components. Always install Fuel System Caps to any open orifices
or tubes.
NOTE: Use a back-up wrench to prevent the fittings in the high-pressure fuel injection pump from turning.
Remove the nuts and the copper sealing washers for the high-pressure fuel injection pump. Remove the high-pressure fuel injection pump-to-fuel
cooler return tube and position the high-pressure fuel injection pump supply tube aside.
^
Discard the copper sealing washers.
11. Disconnect the electrical connector for the engine cooling fan. Squeeze the tabs and remove the cooling fan electrical connector from the stator.
12. NOTE: The cooling fan has a LH thread.
Using the special tools, remove the engine cooling fan.