F 550 2WD Super Duty V8-6.4L DSL Turbo (2008)
SuperCab
NOTE: LH shown, RH similar.
2. Remove the 2 rear window latch screws and position aside the rear window latch.
3. NOTE: Inspect the shoulder safety belt guide and cover for damage. If the shoulder safety belt guide or cover is damaged or the cover does not
remain closed, install a new shoulder safety belt guide.
Remove the D-ring.
1
Open the D-ring cover.
2
Remove the D-ring bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
3
Remove the D-ring from the safety belt shoulder height adjuster.
4. Remove the rear door upper trim panel.
-
Pull outward to release the rear door upper trim panel clips.
Crew Cab
5. Remove the B-pillar trim panel.
All vehicles
6. Remove the safety belt shoulder height adjuster cover.
7. Remove the safety belt shoulder height adjuster bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
8. Remove the safety belt shoulder height adjuster.
-
Slide the safety belt shoulder height adjuster up and pivot the top away from the sheet metal, disengaging the upper tab from the sheet metal.
-
Rotate the safety belt shoulder height adjuster 90 degrees and rotate the lower tab out of the sheet metal.
9. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
10. Check the active restraint system for correct operation.