F 550 2WD Super Duty V8-6.4L DSL Turbo (2008)
9. Lower the transmission onto the rear insulator and install the bolts.
^
Tighten to 103 Nm (76 ft. lbs.).
Vehicles equipped with a fixed yoke
10. Install the output shaft flange and a new bolt.
^
Tighten to 130 Nm (96 ft. lbs.).
RWD vehicles
11. Install the rear driveshaft.
4WD vehicles
12. Install the transfer case.
All vehicles
13. Start the engine. Move the transmission range selector lever through all the gear ranges, checking for engagements.
14. CAUTION: The use of any other transmission fluid than specified can result in the transmission failing to operate in a normal manner or
transmission failure.
With the vehicle in NEUTRAL, engine running and the transmission at normal operating temperature 66-77° C (150-170° F), check and adjust the
transmission fluid level, and check for any leaks. If fluid is needed, add fluid in increments of 0.24L (0.5 pt) until the correct level is achieved
(fluid should be in the hot range cross-hatched area of the fluid level indicator).