ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Steering System - General Information|Page 5943 > < Steering System - General Information|Page 5941
Page 9
background image

2. Remove the Injector Driver Module (IDM) relay to prevent engine starting.
3. Raise the front wheels off the floor. 

4. CAUTION:  Do not crank the engine for more than 15 seconds at a time. Allow the starter to cool for 1 minute before cranking again. Premature

starter failure can occur. Do not hold the steering wheel against the stops for more than three to five seconds at a time. Damage to the power
steering pump could occur.

Turn the steering wheel from stop-to-stop while cranking the engine.

5. Lower the vehicle.

Steering System - General Information|Page 5943 > < Steering System - General Information|Page 5941