F 550 4WD Super Duty V10-6.8L VIN S (2000)
Harmonic Balancer - Crankshaft Pulley: Service and Repair
Special Tools
Removal
1. Remove the engine cooling fan and fan shroud.
2. Remove the drive belt.
3. Raise the vehicle on a hoist.
4. Remove the crankshaft pulley bolt.
5. Using the Crankshaft Damper Remover, remove the crankshaft pulley.
Installation
1. Note: If not secured within 4 minutes, the sealant must be removed and the sealing area cleaned with Metal Surface Cleaner F4AZ-19A536-RA or
equivalent meeting Ford specification WSE-M513392-A. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer. Failure
to follow this procedure can cause future oil leakage.
Apply silicone to the Woodruff key slot in the crankshaft pulley.
^
Use Silicone Gasket and Sealant F7AZ-19554-EA or equivalent meeting Ford specification WSE-M4G323-A4.