F 550 4WD Super Duty V10-6.8L VIN S (2000)
7. Tighten the five bracket nuts.
CAUTION: Overtightening of the nut will cause the stud to break away from the floor pan.
8. Reattach the ABS wiring harness and position the fender splash shield in the wheel well.
9. Install the vacuum reservoir retaining nuts.
10. Install the fender splash shield fasteners, four screws, three bolts, and three pin-type retainers.
11. Install both RH wheels.
12. Lower the vehicle.
13. Evacuate, leak test and charge the A/C system. Refer to: Heating and Air Conditioning, Service and Repair, Evacuating and Charging
Procedure, See: Heating and Air Conditioning/Service and Repair/Evacuation and Charging Procedure
Line - Condenser to Receiver Drier, Motorhome Chassis
