F 550 4WD Super Duty V10-6.8L VIN S (2000)
9. NOTE: Offset the special tool to obtain an accurate reading.
Rotate the special tool several half-turns to seat the pinion bearings. Position the special tool as shown.
10. Install the special tool.
1
Position the special tool.
^
For model 50 axles, use tool 205-158.
^
For model 60 axles, use tool 205-DO33.
2
Install the bearing caps.
3
Install the bolts.
11. NOTE: Use a feeler gauge or flat, clean drive pinion position shims as a measuring device.
NOTE: Do not attempt to force the gauge or shim between the special tools. A slight drag indicates a correct selection.
Using a feeler gauge or flat, clean drive pinion position shims, measure the gap between the special tools. Record the measurement.
^
Remove the special tools after making the correct shim selection.