F 550 4WD Super Duty V10-6.8L VIN S (2000)
Removal
1. Raise the vehicle on a hoist or raise the rear end of the vehicle with a jack. Install safety stands under the frame rails and lower the jack or hoist far
enough to allow the rear axle to drop into the rebound position for working clearance.
2. Note: To maintain driveline balance, mark the driveshaft components so they can be reinstalled in their original positions.
Disconnect the driveshaft at the rear axle, and position it aside.
3. Note: Index mark the flange (end yoke for MOTORHOME) to the pinion shaft.
While using a suitable tool to prevent the flange or yoke from turning, remove the pinion nut.
4. Using the 2-Jaw Puller, remove the flange or yoke.
