F 550 4WD Super Duty V10-6.8L VIN S (2000)
Note:
^
Install the rear driveshaft with the index marks aligned.
^
Prior to the third removal, clean the bolt threads and apply Loctite(R) 242 or equivalent.
Follow the removal procedure in reverse order.
Rear, Two-Piece
Removal
1. Raise and support the vehicle.
2. Index mark the driveshaft at the axle flange.
3. WARNING: Replace with new bolts and retainers after the third removal.
Disconnect the driveshaft from the axle flange.
