F 550 4WD Super Duty V10-6.8L VIN S (2000)
3. WARNING: Replace with new bolts and retainers after the third removal.
Disconnect the driveshaft from the axle flange.
1. Mark and remove the driveshaft to rear axle bolts.
2. Remove the U-joint retainers. Using mechanics wire, support the driveshaft.
4. WARNING: Replace with new bolts and retainers after the third removal.
Disconnect the driveshaft from the coupling shaft.
1. Mark and remove the driveshaft to coupling shaft bolts.
2. Remove the U-joint retainers.
-
Using mechanics wire, support the driveshaft.
5. Remove the center bearing support bolts.
6. Remove the rear driveshaft assembly.