F 550 4WD Super Duty V8-6.4L DSL Turbo (2008)
Exhaust Temperature Sensor: Service and Repair
EXHAUST GAS TEMPERATURE (EGT) SENSOR
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls or the vehicle may be
damaged.
Turn the ignition switch to the OFF position.
3. Disconnect the appropriate exhaust gas temperature (EGT) sensor electrical connector.
4. NOTE: If necessary, lubricate the exhaust gas temperature (EGT) sensor with penetrating and lock lubricant to ease removal.
Remove the inoperative EGT sensor.
-
To install, tighten to 32 Nm (24 lb-ft).
5. CAUTION: If the exhaust gas temperature (EGT) sensor bends during installation, do not straighten the EGT sensor or it may be
damaged.
To install, reverse the removal procedure.
