ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Fuel Injection Supply Manifold > < Fuel Charging Wiring Harness - 1.6L

Fiesta 1996 (08.1995-02.2002)

Fuel Charging and Controls - 1.25L/1.4L Zetec-SE (Sigma)/1.6L - Fuel Charging Wiring Harness—Vehicles Built From: 02/2000 1.25L Fiesta 1996 (08/1995-02/2002)
Removal and Installation

Removal

  1. Disconnect the battery ground cable. For additional information, refer to Section  414-01 Battery, Mounting and Cables.
  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.

  1. Disconnect the crankshaft position (CKP) sensor and oil pressure switch electrical connectors.
  1. Lower the vehicle.

  1. Disconnect the air cleaner outlet pipe.

  1. Remove the air cleaner cover.
    1. Disconnect the positive crankcase ventilation (PCV) hose.
    1. Remove the air cleaner cover.

  1. Disconnect the fuel charging wiring harness electrical connector.

  1. Disconnect the fuel charging wiring harness electrical connector.
    1. Detach fuel charging wiring harness.
    1. Disconnect the fuel charging wiring harness electrical connector.

  1. Remove the PCV hose.

  1. Detach the fuel lines.

  1. Disconnect the camshaft position (CMP) sensor electrical connector.

  1. Release the fuel charging wiring harness by rotating the clip counterclockwise.

  1. Disconnect the generator electrical connector.

  1. Disconnect the four fuel injector electrical connectors.

  1. Disconnect the T-Map sensor and idle air control (IAC) valve electrical connectors.

  1. Detach the fuel charging wiring harness.
    1. Disconnect the throttle position (TP) sensor electrical connector.
    1. Detach the fuel charging wiring harness.

  1. Detach the fuel charging wiring harness.
    1. Disconnect the cylinder head temperature (CHT) sensor electrical connector.
    1. Detach the fuel charging wiring harness.

  1. Remove the fuel charging wiring harness.
    1. Disconnect the spark plug wires.
    1. Remove the fuel charging wiring harness.

Installation
  1. NOTE:
    NOTE:When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. It may need to be driven 16 km (10 miles) or more to relearn its adaptive strategy.
    To install, reverse the removal procedure.

Fuel Injection Supply Manifold > < Fuel Charging Wiring Harness - 1.6L