| General Procedures NOTE:Make sure that the vehicle is standing on a level surface. | | -
Centralize the steering and lock it in position. | | | -
Loosen the tie-rod end locknuts. | | | -
Remove the steering gear boot outer clamps. | | | -
Rotate the tie-rods an equal amount in either a clockwise or a counterclockwise direction to adjust the toe setting.
For additional information, refer to: Specifications (204-00 Suspension System - General Information, Specifications).
| | | -
Tighten the tie-rod end locknuts.
For additional information, refer to: Tie Rod End (211-03 Steering Linkage, Removal and Installation).
| | | -
Install the steering gear boot outer clamps. | | |
