Ford Workshop Service and Repair Manuals

Expander, Teflon Seal

211-188 (13-015)

Wrench, Hydraulic Line Union Nut

211-269 (13-027)

Remover/Installer, Hose Clamp

303-397 (24-003)

Installer, Camshaft Pulley

303-458 (21−192)

1. Remove the accessory drive belt.
   For additional information, refer to: Accessory Drive Belt - 1.25L Duratec-16V (Sigma)/1.4L Duratec-16V (Sigma)/1.6L Duratec-16V (Sigma), Vehicles Without: Air Conditioning (303-05 Accessory Drive, Removal and Installation).
   

2. Disconnect the power steering fluid reservoir return hose quick release coupling, from either the power steering fluid cooler or the power steering reservoir return hose.
   1. Press the power steering fluid reservoir return hose quick release coupling locking tangs.
   2. Disconnect the power steering fluid reservoir return hose quick release coupling.
   • Allow the fluid to drain into a suitable container.

3. Using the special tool, disconnect the power steering fluid supply hose from the power steering pump.
   • Allow the fluid to drain into a suitable container.

4. 

   CAUTION:Do not disconnect the power steering pump pressure adapter from the power steering pump.
   Using the special tool, disconnect the power steering line from the power steering pump pressure adapter.
   • Allow the fluid to drain into a suitable container.
   • Discard the O-ring seal.

5. Detach the power steering line bracket from the engine block.

6. Remove the power steering pump.

1. 

   NOTE:This step is only necessary when installing a new power steering pump delievered without pulley.
   Using the special tool, install a new power steering pump pulley.

2. 

   NOTE:If installing a new power steering pump, the power steeing pressure line union supplied with the new pump should be removed and retained for further use.
   Using the special tool, install a new O-ring seal onto the power steering line to power steering pump union.
   1. Push the O-ring seal onto the special tool.
   2. Locate the special tool onto the union and install the O-ring seal.

3. 

   NOTE:Make sure the collar on the hose is inserted fully into the quick release coupling.
   To install, reverse the removal procedure.

4. Fill and bleed the power steering system.
   For additional information, refer to: Power Steering System Filling (211-00 Steering System - General Information, General Procedures) /
   Power Steering System Bleeding (211-00 Steering System - General Information, General Procedures).