ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
3 Powertrain > < Steering Column

Fiesta 2002.25 (11.2001-)

Steering Column Switches - Ignition Switch Fiesta 2002.25 (11/2001-)
Removal and Installation

Removal

  1. Disconnect the battery ground cable. For additional information, refer to Section  414-01 Battery, Mounting and Cables.

  1. Detach the audio control switch from the steering column lower shroud (if equipped).
    • Using a thin bladed screwdriver, release the locking tang.

  1. Remove the audio control switch (if equipped).
    • Disconnect the electrical connector.

  1. NOTE:
    NOTE:Turn the steering wheel to access the steering column upper shroud retaining clips.
    Detach the steering column upper shroud from the steering column lower shroud (steering wheel shown removed for clarity).
    1. Using a thin bladed screwdriver, release the two clips (one each side).
    1. Detach the shroud.

  1. Remove the steering column lower shroud (steering wheel shown removed for clarity).
    1. Release the steering column locking lever.
    1. Remove the retaining screws.

  1. Disconnect the ignition switch electrical connector.

  1. Remove the ignition switch.
    • Depress the locking tangs.

Installation

  1. To install, reverse the removal procedure.

3 Powertrain > < Steering Column