| Removal and Installation | | -
Disconnect the battery ground cable.
For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
| | | -
Remove the air cleaner.
For additional information, refer to: Air Cleaner - 2.0L Duratec-HE (MI4) (303-12 Intake Air Distribution and Filtering, Removal and Installation).
| 3. Remove the components in the order indicated in the following illustration(s) and table(s). 1 - Battery positive terminal clamp cover 2 - Battery junction box (BJB) cable electrical connector to battery cable retaining nut 3 - Battery positive terminal clamp 5 - Battery cable retaining clip 6 - Battery cable retaining clip 7 - Starter motor solenoid inline electrical connector 8 - Starter motor solenoid cable electrical connector retaining nut 9 - Starter motor battery positive cable electrical connector retaining nut 10 - Starter motor solenoid electrical connector 11 - Battery cable retaining clip 12 - Battery cable retaining clip 14 - Battery cable retaining clip 15 - Engine wiring harness electrical connector 18 - Crankshaft position (CKP) sensor electrical connector 19 - CKP wiring harness retaining clip 20 - Battery cable retaining clip 21 - Generator electrical connector 4. To install, reverse the removal procedure. Removal Details Item 4 : Wiring harness support | | -
Detach the battery cable from the wiring harness support. | Item 13 : Engine wiring harness retaining clip | | -
Detach the engine wiring harness from the battery cable retaining clip | Item 16 : Power steering line retaining clip | | -
Detach the power steering line from the battery cable inline fuse holder | Item 17 : Battery cable inline fuse holder | | -
Detach the battery cable inline fuse holder from the valve cover and intake manifold. | Installation Details Item 22 : Battery cable to generator electrical connector NOTE:The battery cable to generator electrical connector must follow the profile of the generator as closely as possible. | 
