| Removal and Installation Audio unit removal tools (GV3301) Removal | | -
If a new audio unit is to be installed, connect WDS and upload the audio unit configuration information using the Programmable Modules Installation Routine, prior to commencing the removal of the audio unit. | NOTE:When installing the audio unit removal tools, make sure that the wording on the audio unit removal tools is followed, TOP L indicates the top of the tool, left-hand side of the audio unit and TOP R indicates the top of the tool, right-hand side of the audio unit. | | -
Using the audio unit removal tools, detach the audio unit from the instrument panel. | | | -
Disconnect the audio unit electrical connector. - Release the locking tangs.
| | | -
Disconnect the antenna cable electrical connector and remove the audio unit. | Installation | | -
CAUTION:To prevent possible damage to the audio unit while connecting the audio unit electrical connector, make sure that the antenna cable electrical connector is connected first. CAUTION:The audio unit wiring harness must not become trapped when installing the audio unit. NOTE: Remove the audio unit removal tools from the audio unit by releasing the spring clips before installing the original audio unit. NOTE:When installing a new audio unit, the audio unit must be configured by selecting the Programmable Module Installation Routine on WDS. To install, reverse the removal procedure. | | |
