ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

417-01 Exterior Lighting|Specifications > < Rear Lamp Assembly - Vehicles Built Up To: 10-2005
Exterior Lighting - Headlamp Assembly Fiesta 2002.25 (11/2001-)
Removal and Installation

Removal

All vehicles

  1. Remove the radiator grille.
Vehicles built from 08/2005

  1. Partially detach the front bumper cover from the hood lock panel.
    • Pull the front bumper cover forward to gain access to the lower headlamp bolt.
All vehicles

  1. Unscrew and remove the headlamp bolts.

  1. CAUTION:
    CAUTION:Do not damage the fixing points of the headlamps during removal.
    Detach the headlamp from the hood lock panel.

  1. Remove the headlamp assembly.
    • Disconnect the headlamp electrical connector.

Installation

All vehicles

  1. Connect the headlamp connector.

  1. NOTE:
    NOTE:Clean the lens with a damp cloth to prevent the build-up of electrostatic charge, which could cause dust to stick to the plastic lens.
    NOTE:
    NOTE:Check that the headlamp is engaged at the fixing points.
    Install the headlamp assembly.

  1. Screw in the headlamp bolts.
Vehicles built from 08/2005

  1. Fit the front bumper cover.
All vehicles

  1. Install the radiator grill.
  1. Adjust the headlamp.
    For additional information, refer to: Scheinwerfer einstellen (417-01 Außenbeleuchtung, General Procedures).

417-01 Exterior Lighting|Specifications > < Rear Lamp Assembly - Vehicles Built Up To: 10-2005