Glass, Frames and Mechanisms - Rear Door Window Regulator
Fiesta 2002.25 (11/2001-)
Removal and Installation
Removal
Remove the rear door trim panel. For additional information, refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
Install the window regulator handle.
Remove the grommet.
Detach the rear door window glass from the window glass clamp.
Align the window glass clamp with the access hole.
Depress the locking tang.
CAUTION:Make sure the door window glass is adequately supported at the top of the window opening.
Raise the door window glass by hand and secure using a suitable wedge or tape.
Close the rear door.
Detach the wiring harness from the B-pillar.
Disconnect the wiring harness at the B-pillar and push it into the door.
Open the rear door.
Remove the rear door latch retaining screws.
Remove the exterior rear door handle cover retaining screw and the exterior rear door handle cover.
Remove the exterior rear door handle.
Remove the exterior rear door handle gasket.
Remove the exterior rear door handle reinforcement plate retaining nut.
Push the exterior rear door handle reinforcement plate into the door by releasing the clips.
Remove the rear door inner panel retaining bolts.
NOTE:When lifting the rear door inner panel away from the lower edge of the door panel, make sure the window regulator is clear of the door panel.
Remove the rear door inner panel.
Rotate the rear door inner panel counterclockwise and push it forwards.
Lift the rear door inner panel away from the lower edge of the door panel.
Pull the rear door inner panel downwards to release it.
Rotate the rear door inner panel to access the window regulator.
