Five Hundred 2WD V6-3.0L VIN 1 (2006)
Wagon
Removal and Installation
Sedan
1. Remove the rear bumper cover.
Wagon
2. With the vehicle in NEUTRAL, position it on a hoist.
All vehicles
3. Disconnect the parking aid sensor electrical connector.
4. NOTE: Press the retaining tabs to release the sensor(s).
Remove the parking aid sensor(s).
5. To install, reverse the removal procedure.
-
Paint the sensor(s) with one coat of paint (basecoat and clear coat).
-
Using the diagnostic tool, verify that the parking aid sensor PIDs read no object present, and that the parking aid sensor attenuation PIDs read
between 0.8 - 1.6 ms. If the parking aid sensor attenuation PIDs do not read between 0.8 - 1.6 ms, the paint is too thick on the sensor(s) and it
will be necessary to repaint the sensor(s) as required.