Five Hundred 2WD V6-3.0L VIN 1 (2006)
6. Release the horn and with a suitable tool, lift the end of the wire clip over the post causing both ends of the wire clip to overlap.
7. NOTE: When the driver air bag module wire clip is released correctly, the wire clip will easily slide into place and the 2 wire clip hook ends will
come to rest between the 2 inner posts.
With the wire clip ends in the overlapped position, actuate the horn at the upper part of the air bag cover, then push on both ends of the wire clip
inward (toward the center of the steering wheel) to release the driver air bag module from the steering wheel.
8. NOTE: Label the driver air bag module squib number on the driver air bag module electrical connectors before disconnecting.
Release the two retaining tabs on each driver air bag module electrical connector and disconnect both connectors.
9. Disconnect the horn and accessories electrical connectors and remove the driver air bag module.
Installation
Vehicle repairs reusing the same driver air bag module