Five Hundred 2WD V6-3.0L VIN 1 (2006)
8. Enlarge both bolt holes in the lower arm to 3/4" (19 mm) using a step drill or equivalent. (Figure 2)
9. After enlarging the bolt holes, measure the distance from each hole to the outer and bottom edge of the arm. If the distance is equal to or greater than
13/64" (5 mm), proceed to Step 10. If the distance is less than 13/64" (5 mm), replace the lower arm. (Figure 3)
10. Repaint any bare metal areas.
11. Assemble the lower arm to the wheel knuckle with a new bolt and nut.
12. Push inward on the lower wheel knuckle while tightening the new bolt and nut to 96 lb/ft (130 N.m).
13. Assemble the trailing arm, stabilizer bar and wheel(s) using new fasteners. Refer to WSM, Section 204-02.
NOTE
ALL FINAL FASTENER TORQUES SHOULD BE MADE WITH SUSPENSION AT CURB HEIGHT.
14. Check the rear wheel camber to ensure it is within specification. Adjust rear wheel toe to specification. Refer to WSM, Section 204-00.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage