Five Hundred 2WD V6-3.0L VIN 1 (2006)
Rear Knuckle Alignment Link: Service and Repair
Toe Link
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in
major service expense. A new part with the same part number, or an equivalent part, must be installed if installation is necessary. Do not use a new
part of lesser quality or substitute design. Torque values must be used as specified to make sure of correct retention of these parts.
1. Remove the wheel and tire assembly.
2. Remove the wheel speed sensor wire from the toe link.
3. Remove and discard the toe link-to-knuckle bolt.
^
To install, tighten to 100 Nm (74 ft. lbs.).
4. Remove and discard the toe link-to-subframe nut and bolt.
^
To install, tighten to 100 Nm (74 ft. lbs.).
5. NOTE: Always install new suspension fasteners.
To install, reverse the removal procedure.
^
Check and, if necessary, adjust the rear toe.