Five Hundred 2WD V6-3.0L VIN 1 (2006)
5. Once the transmission fluid temperature range is in the 43°C - 47°C (109°F - 117°F) range, place your foot on the brake and move the
transmission selector level through all gear positions placing it in PARK.
6. Remove the fluid level indicator and wipe it with a clean lint free rag. Place the fluid level indicator back into the fluid level indicator tube.
7. Remove the fluid level indicator and check for correct fluid level. The fluid level should be at the bottom of the top level indicator hole with the
CVT automatic transmission fluid temperature in the 43°C - 47°C (109°F - 117°F) range.
8. If fluid needs to be added, add clean CVT automatic transmission fluid in 0.25L (1/2 pint) increments through the fluid fill plug located on the
top of the transaxle near the fluid level indicator. Do not over fill the transaxle and make sure the fluid temperature is in the correct range 43°C -
47°C (109°F - 117°F) or internal damage to the transaxle will occur.
^
To install, tighten to 35 Nm (26 ft. lbs.).
^
The wrench light on the dash will illuminate if the fluid level is low during the fluid refill process and the vehicle may experience harsh
engagements.
High Fluid Level (CVT)
A fluid level that is too high may cause the fluid to become aerated due to the churning action of the rotating internal parts. This will cause foaming,
loss of fluid from the vent tube, fluid level indicator tube and possible transaxle malfunction and/or damage. If an overfill reading is indicated, loosen
the fluid drain plug and allow a small amount of fluid to drain.
Low Fluid Level (CVT)
A low fluid level could result in poor transaxle engagement, slipping of the chain, malfunction and damage to the transaxle variators. This could also
indicate a leak in one of the transaxle seals or gaskets.