Five Hundred 2WD V6-3.0L VIN 1 (2006)
8. Cut the urethane adhesive applicator tip to specification.
9. NOTE: Use either a high-ratio, electric or battery-operated caulk gun that will apply the urethane with less effort and continuous bead.
Apply urethane adhesive on top of the existing trimmed urethane adhesive bead on the pinch weld. Make sure that all gaps in the urethane
adhesive are smoothed into one continuous bead starting and ending at the bottom of the rear quarter window glass opening near the center.
10. NOTE: Before the urethane has set, partially lower the windows to prevent the glass from being pushed out of position when a door is closed.
Install the rear quarter window glass on the vehicle aligning it with the markings made previously.
11. CAUTION: When installing urethane-installed glass parts, the vehicle must not be driven until the urethane has cured. Adequate cure
time is specified on the drive away chart for each urethane product as the temperatures and humidity vary. Inadequate or incorrect
curing can adversely affect the retention of the windshield.
After the urethane has cured, check the rear quarter window glass seal for air or water leaks through the urethane adhesive bead and add urethane
adhesive as necessary.
12. Install the parcel shelf, C-pillar and D-pillar trim panels.