Five Hundred 2WD V6-3.0L VIN 1 (2006)
6. Disconnect the door latch and door lock linkages.
-
Disconnect the clips.
7. Disconnect the window motor electrical connector, then position the wiring harness aside.
-
Disconnect the 4 wiring harness retainers and the grommet.
-
Push the grommet through the opening and into the door panel.
8. Remove the interior door handle bolt, and position the door handle aside.
-
To install, tighten to 8 Nm (71 lb-in).
9. NOTE: If the window regulator motor is inoperative, remove it.
Lower the window until the glass clamp bolts can be accessed through the rear access hole and front door speaker opening.