Five Hundred AWD V6-3.0L VIN 1 (2005)
4.
Align rear edge of molding to the edge of door (Figure 5).
5.
Roll the molding upward and run your hands along the full length of the molding while applying steady pressure toward the vehicle to ensure good
adhesion of the tape.
6.
Locate lower tape pull-tab and remove.
7.
Attach lower molding to vehicle and run your hands along the full length of the molding while applying steady pressure toward the vehicle to
ensure good adhesion of the tape.
8.
Repeat process for other side of vehicle.
REAR DOOR LOWER BODY SIDE MOLDING INSTALLATION
1.
Clean door surface from bottom edge approximately 6" (15 cm) up with a alcohol wipe.
2.
Remove upper tape strip cover using pull-tab provide.
3.
Align lower (thin) edge of molding to lower edge of door (Figure 4).
4.
Align rear edge of molding to rear edge of door (Figure 5).
5.
Roll the molding upward and run your hands along the full length of the molding while applying steady pressure toward the vehicle to ensure good
adhesion of the tape.
6.
Locate lower tape pull-tab and remove.
7.
Attach lower molding to vehicle and run your hands along the full length of the molding while applying steady pressure toward the vehicle to
ensure good adhesion of the tape.
8.
Repeat process for other side of vehicle.
9.
Lower vehicle off hoist.
