Flex AWD V6-3.5L (2009)
Garage Door Opener Transmitter: Pinpoint Tests
Universal Transmitter
Pinpoint Tests
Pinpoint Test A: The Universal Transmitter is Inoperative
Refer to Wiring Diagram Set 89, Interior Lamps for schematic and connector information. See: Diagrams/Electrical Diagrams/Diagrams By Number
Normal Operation
The universal transmitter receives voltage on circuit CLN09 (YE/GN) and ground on circuit GD133 (BK). When a button on the universal transmitter is
pressed, the universal transmitter will illuminate as a prove out. If the universal transmitter is not used for a period of 5 seconds, the universal transmitter
illumination will automatically turn off.
This pinpoint test is intended to diagnose the following:
-
Wiring, terminals or connectors
-
Universal transmitter
-
Receiver unit
PINPOINT TEST A: THE UNIVERSAL TRANSMITTER IS INOPERATIVE
NOTE: Failure to disconnect the battery when instructed will result in false resistance readings. Refer to Battery.
-------------------------------------------------
A1 CHECK THE UNIVERSAL TRANSMITTER
-
Press a button on the universal transmitter.
-
Does the universal transmitter illuminate?
Yes
GO to A2.
No
GO to A3.
-------------------------------------------------
A2 PROGRAM A HAND-HELD TRANSMITTER INTO THE UNIVERSAL TRANSMITTER
-
Program the universal transmitter. Refer to Universal Transmitter Programming See: Programming and Relearning.
-
Does the universal transmitter program successfully?
Yes
The universal transmitter is OK. VERIFY the receiver operates correctly.
No
INSTALL a new LH sun visor assembly. TEST the system for normal operation.
-------------------------------------------------
A3 CHECK CIRCUIT CLN09 (YE/GN) FOR VOLTAGE
-
Ignition OFF.
-
Disconnect: LH Vanity Mirror Lamp C907.
-
Ignition ON.
-
Measure the voltage between the LH vanity mirror lamp C907-1, circuit CLN09 (YE/GN), harness side and ground.
