Flex AWD V6-3.5L (2009)
-
Is any voltage present?
Yes
REPAIR circuit CAT19 (BU) for a short to voltage. TEST the system for normal operation.
No
INSTALL a new TBC module. TEST the system for normal operation.
-------------------------------------------------
AE3 CHECK THE TBC MODULE OUTPUT
-
Set the gain on the TBC module to the maximum setting.
-
While applying the brake pedal, measure the voltage between the trailer tow connector electric brake control supply pin, circuit CAT19 (BU),
component side and ground.
-
Is the voltage greater than 10 volts?
Yes
The vehicle is operating correctly. SEND the trailer to an authorized camper/trailer repair facility.
No
GO to AE4.
-------------------------------------------------
AE4 CHECK FOR VOLTAGE TO THE TRAILER TOW CONNECTOR
-
Disconnect: Trailer Tow C4099.
-
NOTE: Make sure the gain is set to the maximum setting.
-
While applying the brake pedal, measure the voltage between the trailer tow C4099-3, circuit CAT19 (BU), harness side and ground.
-
Is the voltage greater than 10 volts?
Yes
INSTALL a new trailer tow connector. TEST the system for normal operation.
No
GO to AE5.
-------------------------------------------------