Flex AWD V6-3.5L (2009)
-
Is the resistance less than 5 ohms?
Yes
CONNECT the negative battery cable. GO to G6.
No
REPAIR the circuit for high resistance. CONNECT the negative battery cable. TEST the system for normal operation.
-------------------------------------------------
G6 CHECK FOR CORRECT DSM OPERATION
-
Disconnect the DSM connectors.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the DSM connectors and make sure they seat correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new DSM. REFER to Driver Seat Module (DSM) See: Mirrors/Memory Positioning Systems/Memory Positioning Module/Service and
Repair. TEST the system for normal operation.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.
-------------------------------------------------
Pinpoint Test H: DTC U0140
Driver Seat Module (DSM)
Pinpoint Tests
Pinpoint Test H: DTC U0140
Normal Operation
-
DTC U0140 (Lost Communication With Body Control Module (GEM) - set by the Driver Seat Module (DSM) if data messages received from the
Smart Junction Box (SJB) over the Medium Speed Controller Area Network (MS-CAN) are missing for 15 seconds or longer.
This pinpoint test is intended to diagnose the following:
-
Module communication
-
DSM
PINPOINT TEST H: DTC U0140
-------------------------------------------------
H1 VERIFY CUSTOMER CONCERN
-
Ignition ON.
-
Verify that there is an observable symptom present.
-
Is an observable symptom present?
