Flex AWD V6-3.5L (2009)
5. Remove the front and rear door scuff plates.
-
Pull upward to release the clips.
6. Remove the lower B-pillar trim panel.
-
Pull outward on the trim panel to release the clips.
7. Remove the safety belt D-ring cover.
8. Remove the safety belt D-ring bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
9. Remove the upper B-pillar trim panel bolt and reposition the upper B-pillar trim panel.
10. Remove the upper C-pillar trim panel bolt cover.
11. Remove the upper C-pillar trim panel bolt.
12. Pull outward to release the C-pillar trim panel clips.
13. Reposition the C-pillar trim panel.
14. Remove the D-pillar trim panels. For additional information, refer to D-Pillar Trim Panel See: Trim Panel/Service and Repair/D-Pillar Trim Panel
.
15. Remove the quarter trim panels. For additional information, refer to D-Pillar Trim Panel See: Trim Panel/Service and Repair/D-Pillar Trim Panel.
16. If equipped, remove the DVD entertainment system.
Vehicles equipped with glass roof
17. Remove the rear dome lamp.
-
Using a non-marring tool, pry down from the rear of the dome lamp.
18. Disconnect the dome lamp electrical connector.
-
Feed the dome lamp electrical connector through the dome lamp housing.
All vehicles
19. Remove the sun visor retainer screws and lower the sun visors.
