Flex AWD V6-3.5L (2009)
6. Roll the backrest trim cover all the way down and engage the lower J-clips.
-
Make sure the side air bag module wire harness is routed out from the outboard side of the backrest before engaging the lower J-clips.
-
Make sure the backrest feed wire harness is routed out from the inboard side of the backrest before engaging the lower J-clips.
7. Attach the cushion side shield in the following sequence.
1. Return all retaining clips back to the cushion side shield before attaching to the seat.
2. Align the 4 cushion side shield clips to the seat and push in seating the clips.
3. Install the screw at the front of the cushion side shield.
4. Install the screw at the rear of the cushion side shield.
5. Install the scrivet at the rear of the cushion side shield.
8. Install the recliner cover in the following sequence.
1. Return the barrel nut back to the seat before attaching to the seat.
2. Slide the recliner cover post into the barrel nut on the seat.
3. Install the screw at the rear of the recliner cover.
4. Install the scrivet at the rear of the recliner cover.
9. Install the front seat. For additional information, refer to Seat - Front See: Service and Repair/Front Seats/Seat - Front.
