Flex AWD V6-3.5L (2009)
10. Separate the cushion trim cover rear J-clip.
11. Open the 2 retainers under the seat at the rear and separate the recliner cable.
12. Remove the 4 recliner-to-seat track bolts and remove the backrest assembly.
Installation
1. Position the backrest assembly to the seat track and install the 4 recliner-to-seat track bolts finger-tight.
2. Tighten the 4 recliner-to-seat track bolts in the following sequence.
1. Tighten the rear outboard bolt to 63 Nm (46 lb-ft).
2. Tighten the rear inboard bolt to 63 Nm (46 lb-ft).
3. Tighten the front inboard bolt to 63 Nm (46 lb-ft).
4. Tighten the front outboard bolt to 63 Nm (46 lb-ft).
3. Position the recliner cable into the 2 retainers under the seat and close the retainers.
4. Attach the cushion trim cover J-clip at the rear.
5. Install the inboard recliner lower cover in the following sequence.
1. Align the inboard recliner lower cover to the inner cover and push in, seating the rear clips.
2. Install the screw at the side of the inboard recliner lower cover.
3. Install the screw at the back of the inboard recliner lower cover.
