Flex AWD V6-3.5L (2009)
1. Squeeze the power lumbar retaining clip together and engage it into the backrest frame.
-
Repeat for the power lumbar retaining clip on the other side.
2. Connect the power lumbar motor electrical connector.
5. WARNING: Before installing the seat side air bag module/deployment chute assembly:
-
Inspect the side air bag module and mounting surfaces for any damage or foreign material.
-
Remove any foreign material from the mounting surfaces of the deployment chute, the seat backrest frame mounting bracket and the
air bag module cavity in the seat backrest foam pad.
-
Install new parts if damaged.
Failure to follow these instructions may result in the seat side air bag deploying incorrectly, which increases the risk of serious personal
injury or death in a crash.
NOTE: The side air bag modules are keyed left and right. If the side air bag module locator pin does not align to the backrest frame hole, the
wrong side air bag module is being installed.
Position the 2 side air bag module studs and locator pin through the backrest frame and install the 2 nuts.
-
Tighten to 10 Nm (89 lb-in).
6. Route and attach the side air bag module wire harness to the backrest frame.
7. WARNING: Inspect the seat side air bag module cavity in the seat backrest foam pad for any foreign material. If any foreign material is
found, remove it. Failure to follow these instructions may result in the seat side air bag module deploying incorrectly and increases the
risk of serious personal injury or death in a crash.
Position the backrest frame assembly into the backrest foam pad.
8. If equipped, connect the backrest heated seat mat and attach the connector pin-type retainer to the backrest frame.
