Flex AWD V6-3.5L (2009)
1. Remove the screw at the back of the cushion side shield.
2. Remove the screw at the side of the cushion side shield.
3. Remove the screw at the front of the cushion side shield.
4. Pull out on the cushion side shield to release the clips and separate.
7. Remove the outboard recliner upper cover.
1. Pull at the front and release the clip.
2. Pivot the top of the outboard recliner upper cover back and remove.
-
Pull the fold-flat release strap out through the opening.
8. Using the strap on the outboard recliner, fold the backrest down to the fold-flat position.
9. Separate the wire harness and cable retainers.
1. Remove the pin-type retainer, release all the outboard cushion trim cover J-clips and position the cushion trim cover flap up.
2. If equipped, separate the manual lumbar cable retainers.
3. If equipped, pull the manual lumbar cable cover out of the adjuster.
4. Separate the side air bag module wire harness pin-type retainers.
-
Route the side air bag module wire harness out from under the seat.
5. Separate the outboard fold-flat cable retainer and cover from the outboard recliner.
10. If equipped, remove the manual lumbar cable from the adjuster in the following sequence.
-
Pull the lumbar cable cover out of the adjuster.
-
Remove the cable end from the adjuster.
