Flex AWD V6-3.5L (2009)
5. Remove the pivot bolt.
-
To install, tighten to 22 Nm (16 lb-ft).
6. Invert the backrest trim cover and remove 2 rows of 3 hog rings.
7. NOTE: Head restraint guide with release button goes on the LH side.
Release 2 tabs on each head restraint guide and remove.
8. Remove the backrest trim cover.
-
Pull the strap through the trim cover.
9. To install, reverse the removal procedure.
Seat Cushion Cover - Third Row
Seat Cushion Cover - Third Row
Removal and Installation
1. Remove the 2 screw and pull the cushion handle out of the pocket.
2. Separate the pivot release cable and casing and remove the pivot release handle.
3. Remove the 2 screws on each side at the bottom of the load floor panel.
4. Pull out to release the retainers and remove the load floor panel.
-
Use a suitable tool to disengage the load floor from the seat.
5. Remove the screw, release the tab and remove the floor latch cover.
6. Release the cushion trim cover retainers from the cushion frame.
7. Remove 2 rows of 3 hog rings and remove the cushion trim cover.
-
On assembly, the lower anchors and tethers for children and child safety seat tether anchor must be accessible through the trim cover.
8. To install, reverse the removal procedure.
