Flex AWD V6-3.5L (2009)
Brake Flexible Hose
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result
in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTICE: Make sure to protect the brake pads from contamination from the brake fluid during the brake flexible hose installation and
the brake caliper bleeding.
Remove the brake caliper flow bolt and discard the 2 copper washers.
-
To install, tighten to 47 Nm (35 lb-ft).
3. Disconnect the brake tube fitting from the brake flexible hose.
-
To install, tighten to 17 Nm (150 lb-in).
4. Remove the hose bracket bolt and the brake flexible hose.
-
To install, tighten to 30 Nm (22 lb-ft).
5. To install, reverse the removal procedure.
-
Lubricate the brake caliper flow bolt threads and new washers with clean brake fluid before installing the brake caliper flow bolt into the brake
caliper.
-
Bleed the brake caliper.
