Flex AWD V6-3.5L (2009)
Installation
1. Lubricate the crankshaft front seal inner lip with clean engine oil.
2. NOTE: Lubricate the outside diameter sealing surfaces with clean engine oil.
Using the Front Cover Oil Seal Installer and Crankshaft Vibration Damper Replacer, install the crankshaft pulley.
3. Using the Strap Wrench, install the crankshaft pulley washer and new bolt and tighten in 4 stages.
-
Stage 1: Tighten to 120 Nm (89 lb-ft).
-
Stage 2: Loosen one full turn.
-
Stage 3: Tighten to 50 Nm (37 lb-ft).
-
Stage 4: Tighten an additional 90 degrees.
4. Install the accessory drive belt and the power steering belt.
