Flex AWD V6-3.5L (2009)
Fuel Pump Control Unit: Service and Repair
Fuel Pump Control Module
Removal and Installation
1. Remove the RH C-pillar trim panel.
2. Disconnect the Fuel Pump (FP) module electrical connector.
3. Release the wire harness retainer clip.
4. NOTICE: Do not overtighten the fasteners or damage to the module will occur.
Remove the 2 FP control module nuts.
-
To install, tighten to 5 Nm (44 lb-in).
5. To install, reverse the removal procedure.
