Flex AWD V6-3.5L (2009)
Air Bag: Service and Repair
Passenger Air Bag Module
Passenger Air Bag Module
Removal and Installation
WARNING: Always carry or place a live air bag module with the air bag and deployment door/trim cover/tear seam pointed away from the
body. Do not set a live air bag module down with the deployment door/trim cover/tear seam face down. Failure to follow these instructions may
result in serious personal injury in the event of an accidental deployment.
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
1. Remove the passenger air bag module-to-crossbeam bolts and instrument panel upper section.
-
To install, tighten to 9 Nm (80 lb-in).
2. Remove the passenger air bag module.
-
Remove the 6 screws and air duct.
-
Remove the 6 nuts and passenger air bag module.
-
To install, tighten to 6 Nm (53 lb-in).
3. To install, reverse the removal procedure.