Flex AWD V6-3.5L (2009)
Removal
NOTE: The Rear Drive Unit (RDU) does not have stub shaft pilot bearings. It has stub shaft seals only.
1. Remove the halfshaft assembly.
2. Using the Torque Converter Fluid Seal Remover and Slide Hammer, remove the stub shaft seal.
Installation
1. NOTE: Lubricate the new stub shaft seal with grease.
Using the Front Axle Oil Seal Installer and Adapter (Handle) for 303-224, install the stub shaft pilot bearing housing seal.
2. Install the halfshaft assembly.
