Flex FWD V6-3.5L (2010)
Vehicles equipped with HPAS
13. Remove the power steering gear support from the underbody of the vehicle.
14. Install the power steering gear-to-front subframe bolts and nuts.
-
Tighten to 117 Nm (86 lb-ft).
15. Install the power steering line bolts.
-
Tighten to 7 Nm (62 lb-in).
16. Install the new stabilizer bar bracket-to-front subframe bolts.
-
Tighten to 50 Nm (37 lb-ft).
17. Install the engine exhaust Y-pipe. For additional information, refer to Exhaust System &/or Catalytic Converter.
Vehicles equipped with EPAS
18. Install the RH and LH exhaust flexible pipes. For additional information, refer to Exhaust System &/or Catalytic Converter.
All vehicles
19. Position the RH engine splash shield and install the 2 lower pin-type retainers.
Vehicles equipped with EPAS
20. Install the underbody shield and the 4 retainers.
All vehicles
21. Install the wheels and tires. For additional information, refer to Wheels and Tires.
22. Check the front end alignment and adjust as necessary. For additional information, refer to Suspension &/or Alignment.