Flex FWD V6-3.5L (2010)
If equipped, remove and discard the 6 driveshaft bolts and position the driveshaft aside.
-
To install, tighten the new bolts to 25 Nm (18 lb-ft).
6. Remove and discard the sway bar link upper nuts and reposition the sway bar.
7. Using a suitable jackstand, support the lower arm.
8. NOTE: Before tightening the lower shock bolts, make sure that the vehicle is at the recorded vehicle ride height. For additional information, refer
to Suspension &/or Alignment.
Remove the rear shock lower bolts.
-
To install, tighten the rear shock lower bolts to 175 Nm (129 lb-ft).
9. Remove the jackstand from the lower arm.
10. Disconnect the main subframe electrical connector.
11. Release the parking brake cable tension. For additional information, refer to Parking Brake System.
12. Disconnect the RH parking brake cable from the front parking brake cable and the frame cable bracket.
13. Remove the rear parking brake cable bracket and reposition.
-
To install, tighten to 15 Nm (133 lb-in).
14. Remove the wheel opening parking brake cable bracket bolts and reposition the brackets.
-
To install, tighten to 15 Nm (133 lb-in).
15. Remove the parking brake cables from the calipers.
16. Remove the rear brake caliper bolts.